Skip to main content

It Has Begun

On a sparkling autumn morning after days of rain, I made a coffee went out and cut wood. The physical beginnings of a micro shanty boat build.

Later that same day I paddled my kayak for four hours to complete the navigation of my local river. With run off and ebb flow, the flow was quite strong. Good lessons for drifting a shanty boat.

Comments

Post a Comment

Popular posts from this blog

Frames Done

Ok now I've finished all four of the Frames, the Bow and Transom Bulkheads and two others between. What impresses me so far it's how simple the build is. The next phase calls for me to cut out and butt join the Sides, assemble the Frames in position and then six the Sides. So I expect that any errors or bows in the Frames will show up then. But that's another day, and besides I'm not too bothered if there are a few wrinkles. She's a Pocket. Shanty Boat after all. Costs to this point are about $A200, and side from the outboard, I reckon the biggest expense apart from ply will be epoxy to waterproof below the waterline. I'm reading a pretty fab ebook at the moment called "Houseboat on the Seine". It's about an American artist who is living with his family in France where he builds and renovating a canal boat as a future residence for his family. The author is a self-confessed landlubber  and is doing the build on the cheap, so it speaks to me. Fa...
Post a Comment
Read more

Painting

Today I began sanding and priming the bulkheads. Unfortunately I tried to save a few dollars and buy a quarter litre of primer. Pffft! I've struggled to paint just the bulkheads before I ran the pot dry. So tomorrow, having realised i need to paint the sides and hull in and out, I will get a 4 litre can of primer. Live and learn!
Post a Comment
Read more

Bulkhead Building

Mpre bulkhead building today. Last time I  thought  "Bulkhead 3.5" was pretty well complete, but no. Today I cut out the forward companionway opening and framed it, and cut limber holes. Framing takes a while because all joins have to be cut and fitted. Anyway after a few hours Bh 3.5 was a shot duck. Mext I prepped the framing for "Bulkhead 10". This bulhead is 10' from the bow and fits at the aft end of rhe main cabin. And prepping the timber means that 35x70mm. DAR pine is ripped down its centre line to make 1 1/2" square timber which is required in the Plans. So already Bulkhead 10 is drafted up, needing joints to be marked off and cut before final assembly. Bow and 3.5 Bulkheads in mock lay up.
Post a Comment
Read more